Search
Info
Please note that we continually improve our products, we reserve the right to make changes without prior notice and are not liable for any damage caused by improper use of our products.
JA - Pipe Plugs
Suitable for TIG-Welding !
|
|
Description
please look under JA modular system.
To seal the pipe ends against contamination during transport and storage.
To seal the pipe ends against unwanted drafts / chimney effect. During preheating, welding and during the heat treatment.
Pipe plugs are always supplied without a hole, but are available on request at an additional cost with bore, provided that the smallest diameter allows a bore.
Please tell us your desired diameter of the bore hole !
Bored Plugs are non-returnable !
Pipe Plugs made of Silicon
Heat-Resistant from - 60 °C to 260 °C.
Hardness: 50°Shore Colour: translucent or black
Pipe Plugs made of Natural Rubber
Heat-Resistant from - 20 °C to 90 °C.
Hardness: 40°Shore Colour: grey
J0200010
Basic equipment Pipe plugs in a case with one silicone plug each (for closing on one side) for use on pipes DN 10 - DN 100 (pipe inside Ø 9 - 110 mm / 3/8 inch - 4 inch), with hose, hose connection (1/4R), aluminum tape and inert gas fingers.
Forming:
Forming with pipe plugs is not a substitute for our forming gas systems but only a temporary solution.
- The entire pipe must be completely flooded with gas.
- It should be noted that the pipe end is closed and has a degassing option.
- The positioning of the diffuser should ideally be under the weld.
Test results and tarnishing
|
|
