E.Jankus GmbH

Industriebedarf und Schweißtechnik

JA - Pipe Plugs

Suitable for TIG-Welding !

Description

This system serves to protect the pipe welding ends from Ø 3,5 mm to Ø 260 mm.
To seal the pipe ends against contamination during transport and storage.
To seal the pipe ends against unwanted drafts / chimney effect. During preheating, welding and during the heat treatment.

Pipe plugs are always supplied without a hole, but are available on request at an additional cost with bore, provided that the smallest diameter allows a bore.
Please tell us your desired diameter of the bore hole !

Bored Plugs are non-returnable !

Pipe Plugs made of Silicon

Heat-Resistant from - 60 °C to 260 °C.
Hardness: 50°Shore Colour: translucent or black

Pipe Plugs made of Natural Rubber

Heat-Resistant from - 20 °C to 90 °C.
Hardness: 40°Shore Colour: grey

Eigene Herstellung e 

Forming:

Forming with pipe plugs is not a substitute for our forming gas systems but only a temporary solution.

  • The entire pipe must be completely flooded with gas.
  • It should be noted that the pipe end is closed and has a degassing option.
  • The positioning of the diffuser should ideally be under the weld.

 

Test results and tarnishing

  • Click to enlarge image a.jpg
  • Click to enlarge image b.jpg
  • Click to enlarge image c.jpg
  • Click to enlarge image d.jpg
  • Click to enlarge image e.jpg
  • Click to enlarge image f.jpg
  • Click to enlarge image g.jpg
  • Click to enlarge image h.jpg
  • Click to enlarge image i.jpg
  • Click to enlarge image j.jpg
  • Click to enlarge image k.jpg
  • Click to enlarge image l.jpg
  • Click to enlarge image m.jpg
  • Click to enlarge image n.jpg
This site uses cookies. By using our services, you agree that we use cookies.
More information Ok